STEP 6: Test the toilet to determine if the repair was successful. Similarly, if this connection is not tight enough, water may leak from the base of the tank. Start by hand-tightening the nut until it cannot turn anymore, then use your channel lock pliers to snug up the connection.ĭon’t over-tighten the water supply line as this can cause the nut to crack, leading to a leak and potential water damage issues. Now that the new fill valve is in place and you have tightened the locking nut to secure the fill valve assembly, the next step is to reattach the water supply line to the base of the toilet tank. STEP 5: Reattach the water supply line and turn on the water. This should be about an inch below the top of the overflow tube to properly fill the tank without water draining into the overflow tube. Place the new fill valve into the open toilet tank and secure it in position by fastening the locking nut on the bottom of the toilet tank.Īdjust the height of the fill valve and the float to ensure that it is sitting at the correct level for the toilet. STEP 2: Turn off the water and disconnect the water supply line.ĭouble check the new fill valve to ensure that it is compatible with your toilet, then remove it from the packaging. Also, have your pliers and new flush valve assembly ready to go. Place a bucket under the water supply line and have a towel on hand in case any water gets on the floor. Like most DIY projects, the first step is preparing the area. RELATED: The Best Toilet Repair Kits STEP 1: Prepare the surrounding area. Generally, you should look for a new fill valve that matches the old valve in size and shape, though you can also pick up a universal toilet fill valve if you aren’t certain which type you need. There are a range of toilet fill valve types available at most home improvement stores. If the toilet overflow tube is the correct height and set to the correct water level but water continues to flow into it, then proceed with your DIY toilet repair. First, though, make sure the overflow tube is the right height for the toilet and that the water level is set to about an inch below the overflow tube. This could indicate that the fill valve is leaking or has failed, in which case you will need a toilet fill valve replacement. However, even if the toilet fill valve isn’t 5 years old yet, you may notice that the toilet keeps running after flushing or runs intermittently when not in use. The toilet fill valve is also located inside the tank, where it’s responsible for allowing water to flow into the tank and shutting off the flow once the water level reaches a set point. The toilet flush valve is the component responsible for emptying the tank into the toilet bowl and closing the connection between the tank and bowl when the tank has been emptied of water. There are two main parts of a toilet tank: the flush valve and the fill valve. Project OverviewĮstimated Cost: $10 to $30 BEFORE YOU BEGIN We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |